In most modern fitted kitchens there is only one
single work top under which cabinets and
electrical appliances are fitted. In this case remove
the work top of the dishwasher by unscrewing the
screws under the rear edge of the top (
a
).
a
a
b
b
Attention
After removing the work top, the screws MUST BE screwed
in
again under the rear
edge of the top (
b
).
The height will then be reduced to 815 mm, as scheduled by the International
Regulations (ISO) and the dishwasher will fit perfectly under the kitchen work
top
.
19
2.
If
dishwasher is installed at the corner of the cabinet,
allow sufficient
space
for
when the door is open.
Cabinet
Dishwasher
Door of
dishwasher
Minimum space
of 50mm
NOTE
:
Depending on where your electrical outlet is, you may need to cut a hole in the
cabinet side.
Tension adjustment of the door spring
1.
The door springs are set at the factory to
the proper tension
and
should not need
adjustment
.
2.
Door spring tension is correct when the
door remains horizontal in the fully opened
position, yet rises to a close with the slight
lift of a finger.
3.
If necessary adjust the tension of the door
springs by using an Allen key
,
turning in a
clockwise motion to tighten the left and
right door springs.
Fitting
Under Existing Work Top
