Protect Against Freezing
1.Cut off the electrical power to the dishwasher.
2.Turn off the water supply and disconnect the water inlet pipe from the water valve.
3.Drain the water from the inlet pipe and water valve. (Use a pan to gather the water)
4.Reconnect the water inlet pipe to the water valve.
5.Remove the filter at the bottom of the tub and use a sponge to soak up water in the sump.
Appropriate
frost
protection
measures
on
the
dishwasher
should be taken in winter
.
After every use
please
operate
as
follows
：
Cleaning the Filter
The
control
panel
can
be
cleaned
by
using
a
lightly
dampened
cloth.
After
cleaning,
make
sure
to
dry
it
thoroughly.
For
the
exterior,
use
a
branded stainless steel cleaning product.
Never
use
sharp
objects,
scouring
pads
or
harsh
cleaners
on
any
part
of
the
dishwasher.
Cleaning
The
Door
To
clean
the
coarse
filter
and
the
fine
filter,
use
a
cleaning
brush.
Reassemble
the
filter
parts
as
shown
in
the
figures
on
page
17
and
reinsert
the
entire
assembly
in
the
dishwasher,
positioning
it
in
its
seat
and
pressing
downwards.
When
cleaning
the
filters,
don't
knock
on
them.
Otherwise,
the
filters
could
become
distorted
and
the
performance
of
the
dishwasher
could
be
decreased.
To clean the edge around the door, you should use only a soft warm, damp cloth.
To avoid penetration of water into the door lock and electrical components, do not
use a spray cleaner of any kind.
Never use a spray cleaner to clean the door panel as it may damage the door lock
and electrical components.
Abrasive agents or some paper towels should not be used because of the risk of
scratching or leaving spots on the stainless steel surface.
If your dishwasher cannot work because of the ice,
please contact professional service persons.
- Inspect the filters for blocking after every time the dishwasher has been used.
- By unscrewing the coarse filter, you can remove the filter system. Remove any food remnants and
clean the filters under running water.
Notes:
The entire filter assembly should be cleaned once a week.
Cleaning
the
Spray
Arms
It
is
necessary
to
clean
the
spray
arms
regularly
as
hard
water
chemicals
will
clog
the
spray
arm
jets
and
bearings.
To
remove
the
upper
spray
arm,
hold
the
nut,
rotate
the
arm
clockwise
to
remove
it.
To
remove
the
lower
spray
arm,
pull
out
the
spray
arm
upward.
Wash
the
arms
in
warm soapy
water
and
use
a
soft
brush
to
clean
the
jets.
Replace
them
after
rinsing
them
thoroughly.
18
