POWER AMPLIFIER SECTION
6L6 with 12AX7 driver
Rated Power &Load
5w RMS into 16, ohms
Power @Clipping(Typically)
(5%THD,1KHZ,120vAC line) 5W RMS into 16ohms(Bias must be reduced to
measure)
Frequency Response:
+0,-2db,50HZ to 15KHZ,@, 10w RMS into 16 ohms
Hum &Noise:
Greater than 80 db below rated power
Power consumption:
50wtts 50/60HZ.120Vac(domestic)
PREAMP SECTION
12AX7’s
The following specs are measured @1KHz with the controls present as follows:
Pre
Nominal Level is with Input Gain @6
MINI level is with Input Gain @ 12
Preamp Normal Input
Impedance: Very high Z, 470Kohm
IMPORTANT SAFETY INSTRUCTIONS
IMPORTANT SAFETY INSTRUCTIONS
IMPORTANT SAFETY INSTRUCTIONS
IMPORTANT SAFETY INSTRUCTIONS
WARNING :
WARNING :
WARNING :
WARNING :
When using electric products, basic cautions should always be
followed.
Read all safety and operating instructions before using this product.
Read all safety and operating instructions before using this product.
Read all safety and operating instructions before using this product.
Read all safety and operating instructions before using this product.
1.
All safety and operating instructions should be retained for future reference.
2.
Obey all cautions in the operating instructions and on the back of the unit.
3.
All operating instructions should be followed.
4.
This production should not be used near water, i.e.. a bathroom , sink,
swimming pool, wet basement, etc.
5.
This product should not be placed near a source of heat such as a stove,
radiator, or another heat producing amplifier.
6.
This product should be located so that its position does not interfere with its
proper ventilation. It should not be placed flat against a wall or placed in a
built-in enclosure that will impede the flow of cooling air
7.
Connect only to a power supply of the type marked on the unit adjacent to
the power supply cord.
8.
Never break off the ground pin on the power supply cord
9.
Power supply cords should always be handle carefully. Never walk or place
equipment on power supply cords. Periodically check cords for cuts or signs
of stress, especially at the plug and the point where the cord exits the unit.
10.
The power supply cord should be unplugged when the unit is to be unused
for long periods of time.
11.
If this products is to be cleaned with damp rag. The vinyl covering used on
some units can be cleaned with a damp rag or an ammonia-based household
cleaner if necessary. Disconnect unit from power supply before cleaning.
12.
If the product is to be mounted in equipment rack, rear support should be
provided.
13.
Care should be taken so that objects do not fall and liquids are not spilled
into the unit through the ventilation holes or any other openings.
14.
This unit should be checked by a qualified service technician if: