SPECIFICATIONS
SPECIFICATIONS
SPECIFICATIONS
SPECIFICATIONS
POWER AMPLIFIER SECTION
4-6BQ5/EL84’s with 12AX7 driver
Rated Power &Load
30w RMS into 16, 4 ohms
Power @Clipping(Typically)
(5%THD,1KHZ,120VAC line) 30W RMS into 16 ohm or 8 ohms(Bias must be
reduced to measure)
Frequency Response:
+0,-2db,50HZ to 15KHZ,@, 20w RMS into 16 ohms
Hum &Noise:
Greater than 80 db below rated power
Power consumption:
150wtts, 50/60HZ. 120Vac (domestic)
PREAMP SECTION
2-12AX7’s
The following specs are measured @1KHz with the controls present as follows:
Pre &Post (lead)@0
Reverb Level @0
Bass &Treble EQ @12
Middle
EQ@0
Channel Select Out
Boost Switch Out
Nominal Level is with Input Gain @6
MINI level is with Input Gain @ 12
Preamp Normal Input
Impedance: Very high Z, 470Kohm
Lead Channel
(Post Gain @ 12)
Nominal Input level –40dBV, 10mV RMS
MINI Input Level: -70dBV, 0.3mV RMS
Normal Channel:
Nominal Input Level:
-17 dBV, 140mV RMS
MINI Input Level: -28dBV, 40mVRMS
Max Input Level: 0dBV 1.0VRMS
Equalization:
(Lead &Normal Channels)
Customer bass, middle & treble passive-type EQ
Effect send
-Load Impedance: 1Kohm or Greater; Nominal Output Level: -6dBV, 0.5V RMS
Effect Return
Impedance: High Z, 2M ohms
Designed input Level:
-6dBV, 0.5VRMS (Switching jack provides Effect Send to Effects Return
connection when not used
External Footswitch Function:
Reverb Defeat
(When reverb control is raised)Normal/lead channel select(when lead activated)