15
KLAXON Mobility GmbH - EN
KLICK devices - End User’s Manual (EN) - rev.7.2 of 2021.11.25
3.
Multi-function control panel (Figure 14) with the Intelligent Cruise Control button (A) and Reverse Gear
switch (B).
4.
Display
5.
Brake levers equipped with parking brake
6.
EBS Button
7.
Display push-buttons panel (Figure 19 ) with “
M
” button (A), “
+
” button (B), “
-
” button (C) and “
POWER
“
button (D)
Once the device has been installed, the battery and the display have been turned on and a speed has been selected,
use the accelerator to make the device start to move (Figure 20). To slow down the device’s speed use the brake
lever or press the “
EBS BUTTON
” (the red button in Figure 20). To stop the device keep squeezing the brake lever
until the KLICK stops completely (Figure 21). The KLICK brake is equipped with an additional safety device that
deactivates the motor and activates the EBS when the lever is operated (Figure 21).
The device is equipped with a reverse gear as standard equipment. To use the reverse:
A.
Move the switch to the right until is located under the “
RIGHT ARROW SYMBOL
” (Figure 22). A flashing
“
R
” symbol will appear on the display.
B.
Press the accelerator until it reaches the maximum speed position. This will activate the reverse gear.
C.
Release the accelerator.
D.
Gently press the accelerator to start moving backward.
DANGER
If the brake has been activated while the reverse gear is engaged, the only way to re-activate the
backward movement is to repeat the procedure in this chapter (chapter 12) starting from step B.
This is due to safety reasons.
To return to the forward gear, release the accelerator and move to the left the switch until it is located in the centre
or under the “
LEFT ARROW SYMBOL
” (Figure 23).
The KLICK models equipped with the STANDARD handlebar are provided with a parking brake (Figure 24).
Here below the instructions to LOCK the parking brake (instructions apply to both left and right brakes):
Activate the brake by squeezing the brake lever (Figure 25).
Lock the brake lever with the parking brake locker (Figure 25).
Release the lever after being sure that the parking brake locker is engaged (Figure 26).
Here below the instructions to UNLOCK the parking brake (instructions apply to both left and right brakes):
Squeeze the brake lever until the parking brake locker is free to move (Figure 27).
Disengage the parking brake locker (Figure 27).
Release the brake lever. The brake and the parking brake locker will return to the same position shown in
Figure 24.
CAUTION
The reverse gear has a warning system to show whether it is selected or not.
The warning is delivered in two ways:
VISUAL-> when the switch is located in the centre or under the “
LEFT ARROW SYMBOL
” the reverse
gear is DISENGAGED; when the switch is located under the “
RIGHT ARROW SYMBOL
” the reverse
gear is ENGAGED. A flashing “
R
” symbol will appear on the display when the reverse gear is engaged.
ACOUSTIC-> when the reverse gear is ENGAGED, the display will emit an acoustic warning that
will be active for all the duration.
CAUTION
After inserting the battery in its housing and locked by turning the key, remove the key and put
it in a safe place. It is absolutely forbidden to use the KLICK device with the key inserted in the
security block.
The accelerator control and the EBS button can be installed either on the left or on the right side
of the handlebar according to the user’s preference.
DANGER
For the installation and positioning of controls (accelerator control and EBS button), contact an
authorised KLAXON service centre.