9
KLAXON Mobility GmbH - EN
KLICK devices - End User’s Manual (EN) - rev.7.2 of 2021.11.25
When the device is in motion, avoid moving the centre of gravity or abruptly moving your body.
It is advisable to drive through narrow passages at minimum speed and with utmost caution.
When using KLICK devices, the risk of tipping-over during cornering increases: reduce speed
before turning. Accelerate again only after completing the curve.
When using KLICK devices, do not make U-turns or turn from a stationary start on slopes greater
than 3° (or lower according to pavement condition) and at a speed higher than level 1 and 3 km/h
(or lower according to pavement condition).
It can be difficult to manoeuvre in front of a lift or at the entrance of a building since the
wheelchair’s turning radius increases when coupled with a KLICK device; this could conflict with
the standards of the buildings or the actual size of the entrances.
When entering a building and/or an elevator, always take into account the turning radius of your
wheelchair equipped with the KLICK device. Avoid driving into situations from which you would
not be capable of exiting because you would be unable to turn your wheelchair.
Absolutely never use the Klick device along tramway, rail and light railway tracks. Pay the utmost
attention at level crossings, keeping the Klick’s and wheelchair wheels at due distance. Failure to
comply with this precaution could cause serious damages to the device and the user. The same
precautions apply to water drains, manholes and all kinds of hollows along the way.
DANGER
Consider that the stopping distance on slopes can be significantly greater than on a flat ground.
Switch off the device before entering and before leaving an indoor ambient.
Potential finger traps are shown in Figure 4.
Potential squeezing points are shown in Figures 5 and 6.
DANGER
Do not start or use the Intelligent Cruise Control function on an uphill slope that is rated above
6°/10% (or lower according to pavement condition) and a downhill slope that is rated above
3°/5% (or lower according to pavement condition).
CAUTION
Handling points for carry the device are shown in Figure 7.
8. MA
RKINGS
The device is uniquely identified by its serial number (SN), shown on the plate of the device, attached to the motor
unit near the battery. The meaning of the symbols shown in the plate are as follows:
Symbol
Description
Manufacturer
Type name
SN
Serial number
Reference Number
Medical Device
Year of manufacture