Operation instruction
Caution:
Read the entire “Important safety information” including all text under subheadings therein before
set up or use of this product.
1. Turn the Hydraulic Oil Return Valve (8) to its “OFF” position.
2. Eight dies are available in this set. Please take the chart for a reference to select a suitable
die and insert them into the Pincer Head (6) of the tool.
3. Insert an electrical terminal (not included) onto the bare end of a wire. Then place the
terminal with its wire between the set of Crimping Dies (6) on the tool.
4. Turn the Hydraulic Oil Return Valve (8) to its “ON” position.
5. Grip the tool firmly. Then slowly squeeze the Pump Handle (1) as many times as necessary
to fully crimp the terminal onto the wire.
6. Once the terminal is crimped, turn the Hydraulic Oil Return Valve (8) to its “OFF” position
to fully retract the Crimping Dies. Then remove the crimped assembly.
7. Store the Hydraulic Wire Crimping Tool in its Carrying Case and keep the Case in a clean,
dry, safe location out of reach of children and other unauthorized persons.
Inspection and Cleaning
Caution:
Procedures not specifically explained in this manual must be performedonly by a qualified
technician.To prevent injury from tool failure: Do not use damaged equipment. If abnormal noise
or
vibration occurs, have the problem corrected before further use.
1. Before each use: Inspect the general condition of the Hydraulic Wire Crimping Tool.
Check for misalignment or binding of moving parts, cracked or broken parts, and any other
condition that may affect its safe operation.
2. To replace the O-rings: Only a qualified service technician should attempt to replace the O-
Rings and/or Ring.
3. To clean the hydraulic wire crimping tool: Use a clean cloth with a mild detergent. Then
dry. Do not use solvents.
