13
EN
• Power cord must not be lengthened.
• Make sure that the power plug is not squashed or damaged by the back of the
appliance. A squashed or damaged power plug may overheat and cause a fire.
• Make sure that you can come to the mains plug of the appliance.
• Do not pull the mains cable.
• This appliance is heavy. Care should be taken when moving it.
• Do not remove nor touch items from the freezer compartment if you hands are
damp/wet, as this could cause skin abrasions or frost/freezer burns.
• Avoid prolonged exposure of the appliance to direct sunlight.
• Do not put hot on the plastic parts in the appliance.
• Do not place food products directly against the rear wall.
•
Do not place carbonated of fizzy drinks in the freezer compartment as it creates
pressure on the container, which may cause it to explode, resulting in damage to
the appliance.
Hints on Cleaning
• Before maintenance, switch off the appliance and disconnect the mains plug from
the mains socket.
• Do not clean the appliance with metal objects.
• Do not use sharp objects to remove frost from the appliance. Use a plastic scraper.
• Regularly examine the drain in the freezer for defrosted water. If necessary, clean
the drain. If the drain is blocked, water will collect in the bottom of the appliance.
Hints on Installation
• Unpack the appliance and check if there are damages on it. Do not connect the
appliance if it is damaged. Report possible damages immediately to the place you
bought it. In that case retain packing.
• It is advisable to wait at least four hours before connecting the appliance to allow
the oil to flow back in the compressor.
• Adequate air circulation should be around the appliance, lacking this leads to
overheating. To achieve sufficient ventilation follow the instructions relevant to
installation.
• The appliance must not be located close to radiators or cookers.
• Make sure that the mains plug is accessible after the installation of the appliance.
• Any electrical work required to do the servicing of the appliance should be carried
out by a qualified electrician or competent person.
