Klarstein 10035055, Руководство пользователя

Страница: 19 / 54

19
EN
Timer settings
• The scope of scheduling is for 0-24 hours, and
press the Plus or Minus button ( or ) each time
to increase or decrease 1 hour. When the set value
is “0H”, press the Minus button to set the time for
“24H”. When the set value is “24H”, press the Plus
button , and the setting time is “0H”. When the set
value is “0H”, the scheduling is canceled. When the
set value is not “0H”, the scheduling is started.
• Set the appointment time, press the timer button or
mode button , or without operation for 5 seconds,
exit scheduling mode.
•
Cancel timer:
If the scheduling time is set, press the
standby button to enter the standby state and
cancel the scheduling.
• After the scheduling is started, press the timer button
to check the remaining time of the appointment
and reset the scheduling time.
• During the scheduled time, the machine is shut down
or started up under temperature control, and the
scheduled time is always normal, and free from down
time. During the scheduled time, it is cleared in case of
power failure.
Memory function
• When started up the machine again and it will operate
according to the status before the last standby.
Safety protection
function
• When the indoor ambient temperature Th exceeds
50 °C under the standby or working state, all outputs
are turned off, the buzzer prompts 10 long beeps, the
digital screen displays „FF“ and flashes at 1 Hz for
75 seconds. As long as there is protection, even if the
ambient temperature is less than 50 °C, the running or
operation cannot be resumed, and the operation can
only be performed after the power is turned off and
on again.
Shut down
• Under the working state, press the standby button
on the control panel to enter the standby state.