10
EN
SAFETY INSTRUCTIONS
• Read all instructions before using the appliance.
• If the supply cord is damaged, it must be replaced by the manufacturer, its service
agent or similarly qualified persons in order to avoid a hazard.
•
This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge,
unless they have been given supervision or instruction concerning use of the
appliance by a person responsible for their safety.
•
Children should be supervised to ensure that they do not play with the appliance.
•
To avoid a hazard due to instability of the appliance, it must be fixed in accordance
with the instruction.
INSTALLATION
• This appliance is designed to be free standing only, and should not be recessed or
built-in.
•
Place your unit on a floor that is strong enough to support the unit when it is fully
loaded.
• To level your unit, adjust the leveling legs at the bottom of the unit.
• This appliance is NOT designed to be installed inside of a cabinet where the front is
covered by any type of door.
• Allow 10 cm of space between the top, back and sides of the unit, which allows the
proper air circulation to cool the compressor and condenser.
•
Locate the unit away from direct sunlight and sources of heat (stove, heater,
radiator, etc.).
• Direct sunlight may affect the acrylic coating and heat sources may increase
electrical consumption. Extreme cold ambient temperatures may also cause the unit
not to perform properly.
• Avoid locating the unit in moist areas.
• Plug the unit into an exclusive, properly installed-grounded wall outlet. Do not
under any circumstances cut or remove the third (ground) prong from the power
cord. Any questions concerning power and/or grounding should be directed
toward a certified electrician or an authorized Avanti Products service center.
• After plugging the appliance into a wall outlet, allow the unit to cool down for 2-3
hours before placing food in the APPLIANCE compartment.
