10
4. Press “START” button to turn unit on. The ice maker begins to work. Note: For the first three cycles,the ice
may be small and irregular in size,and it would last for longer time,maybe even around 60 minutes.
5. If indicator ‚ICEFULL‘ is in red with noise ‚DI DI‘,please take out the ice with the scoop.
6. Press ‚STOP‘ button to stop the machine.
7. Remove the drain plug to drain remaining water from the water reservoir. Screw the drain plug back in place
after the water has been drained.
Cleaning and Care
• Clean the inner liner, water box, ice shovel and evaporator frequently. When cleaning, unplug the unit and
remove the ice cubes. Use a diluted solution of water and vinegar to clean the inside and the outside surface
of the Ice maker. Do not spray Ice maker with chemicals or diluted agents such as acids, gasoline or oil. Rinse
thoroughly before starting.
• Keep ventilation openings in the appliance enclosure, or in the built-in structure, clear of obstruction. Do not
use mechanical devices or other means to accelerate the defrosting process, other than those recommen-
ded by the manufacturer.
• If the machine is reused after a long time , maybe the water pump cannot pump sufficient water due to the
air inside, the ADD WATER water indicator light will turn on in this case . To correct this press the START
button again, then the machine will work normally.
• To ensure the cleanliness of the ice cubes, water in the water reservoir should be replaced every 24 hours.
• If the compressor stops for any reason such as water shortage, too much Ice, power off, etc... Do not start the
system right away, wait 3 minutes, and then re-start the Ice maker.
• Always change with fresh water before starting ice production at initial installation or after long shut-off
periods.
• Auto clean function,if the unit is not used for a long time,before the use,you can plug the unit first,and
then press the button “ON/OFF” button for 5seconds,the unit will clean itself(all indicators illuminate every
5seconds,pump take water for 5times,each time 30seconds)
Troubleshooting
Please note, if the water filled to the evaporator is not symmetrical, small sundries maybe be formed and lod-
ged in the pipe which will mean that water will be filled to the evaporator causing it to jam. Please pull out the
cap of the pipe, then let the water through the pipe in order to clean the pipe, then you can replace the cap. It
will make formal ice cubes.
Problem
Possible Cause
Solution
The compressor works abnormally
with a buzzing noise.
The voltage is lower than recom-
mended.
Stop the Ice maker and do not
restart until the voltage is normal.
The light of ADD WATER is on.
There is no water or water is not
enough.
Press the “STOP” button, fill with
water, and press the “START”
button again to restart.
Содержание 10029294
Страница 1: ...10029294 10029295 Eiswürfelbereiter ...
