Klarstein 10027045, Руководство пользователя

Страница: 24 / 38

Installation
WARNING
Disconnect electrical power before installing dishwasher. Failure to do so can result in death
or electrical shock..
Positioning and leveling
1. Remove the appliance from all packaging and check that it has not been damaged during trans-
portation. If it has been damaged, contact the retailer and do not proceed and further with the
installation process.
2. Check the dishwasher by placing it so that its sides or back panel are in contact with the adjacent
cabinets or even with the wall. This appliance can also be recessed under a single worktop (see
the Assembly instruction sheet).
3. Position the dishwasher on a level and sturdy fl oor. If the fl oor is uneven, the front feet of the
appliance may be adjusted until it reaches a horizontal position (the angle of inclination must not
exceed 2 degrees). If the appliance is levelled correctly, it will be more stable and much less likely
to move or cause vibrations and noise while it is operation.
Connecting the water and electricity supplies
Connection to the water and electricity supplies should only be performed by a qualifi ed technician.
The dishwasher should not stand on top of the water hoses or the electricity supply cable The appli-
ance must be connected to the water supply network using new piping. Do not use old piping.
• Connecting the water inlet hose
Connect the cold water supply hose to a threaded 3/4(inch) connector and make sure that it is
fastened tightly in place. If the water pipes are new or have not been used for an extended period
of time, let the water run to make sure that the water is clear and free of impurities. If this pre-
caution is not taken, there is a risk that the water inlet can get blocked and the appliance could
be damaged.
• Connecting the water outlet hose
Fit the drainage hose of your machine to the drainage pipe without bending. If the length of the
hose is not suffi cient, apply to the authorized service for an extension made from the same mate-
rial as the original. Remember that the length of the hose should not exceed 4meters even when
with an extension. If the drainage hose is longer the 4 m. the dishes will not be cleaned properly
secure your hose fi rmly to the drainage pipe to avoid it coming off during the washing process.
• Electrical connection
Before inserting the plug into the electrical socket, make sure that the socket is earthed and
complies with current regulations. The household electrical supply system should be provided and
should meet requirements of the appliance under normal load. The socket must be compatible with
the plug of the appliance. If this is not the case, ask an authorised technician to replace the plug.
WARNING
Once the appliance has been installed, the power supply cable and the electrical socket
should be easily accessible. The cable should not be bent or compressed. If the power sup-
ply cable is damaged, it must be replaced by the manufacturer or its Technical Service.
Advice regarding the fi rst wash cycle
After the appliance has been installed, immediately before running the fi rst wash cycle, completely
fi ll the salt dispenser with and add approximately 1.2 Kg of salt (see Rinse aid and refi ned salt). The
water may overfl ow: this is normal and is not a cause for concern. It is also normal that the LOW
SALT indicator light continues to fl ash for a few cycles after the salt has been loaded.
24