Klark Teknik HELIX SYSTEM DN9340, Руководство оператора

Страница: 50 / 62

l
abc
Operation DN9344:
Remote control mode
This section describes setting up the DN9344 for remote control operation. Please refer to the DN9340
remote control section (on page 32) for information on controlling the system once it is set up.
Press and hold the SETUP button to enter the SETUP menu. Note that the red alphanumeric
displays are now showing Last Recalled Memory and Communication (COMMS) mode. The
blue display mode indicator lights to emphasise this fact. The UP and DOWN buttons light to
show that they are now active.
Press UP and DOWN on the left-hand half of the unit (Section 1) to select the desired
communications channel. There are 32 possible channels available. Each unit (including the
master) MUST have a unique channel number or the system will not work correctly.
Now press the UP and DOWN buttons on the right-hand half of the unit to select its own,
independent communications channel. The reason for having two separate channel numbers
within one unit is that the DN9344 is seen by the system management software as representing
two individual DN9340 units, each with two channels. This allows DN9340 and DN9344 units
to be freely swapped in and out of the system without changing the mapping between audio
channels and communications channels. In other words, every stereo pair of audio channels
has a communications address, irrespective of whether it is a DN9340 or half a DN9344.
The red alphanumeric displays are now showing the three-character name for each audio
channel. These are set from the master unit. If no names have been entered, the display will
show “---”
Press SETUP to confirm (unit will display password menu). Press SETUP to exit.
42