Klarfit Treppo, Руководство пользователя

Страница: 31 / 44

31
EN
Step 2
Hold the support frame (24) close to the lower main frame (1) and connect the
lower sensor cable (27) of the support frame (24) to the middle sensor cable
(52) of the lower main frame (1).
Note: Make sure the cables are properly connected, otherwise no signal
will be transmitted to the computer (40). The cable connections must be
on the inside of the frame and must not protrude to avoid damaging the
cables.
Connect the support frame (24) to the lower main frame (1) with a hexagon
screw (30), two washers (29) and a nut (28). The washer (29) must be mounted
under the screw head and under the nut (28). Insert the locking pin (31) into
the second hole of the main frame (1). Finally, place the cap (35) on the hex nut
(30) and nut (28).
Note: When connecting the support frame (24) to the lower main frame ( 1),
make sure that the hexagon nut (30) is in the upper opening and the locking
pin (31) is inserted in the lower opening.
Attach the two pedals (12 R+L) to the pedal tubes (22) with two Phillips screws
(10), two spring washers (50) and two washers (11).