TROUBLE SHOOTING
Water Wheeler ASL Electric
PROBABLE CAUSE
CORRECTIVE ACTION
Problem: Motor won’t run
Dead battery or missing battery
Recharge or replace battery.
Battery leads disconnected or badly corroded
Remove battery leads, clean corrosion from battery terminals and
connectors. Reconnect battery leads and tighten wing nuts.
Circuit breaker on control panel tripped
Check prop. Remove weeds, fishing line, rope that may be wound
around prop shaft. Reset breaker.
Circuit braker continues to trip
Remove control panel. Clean all corrosion from terminals. Make
sure connections are tight. If motor still doesn’t run, call KL
Industries for replacement.
Prop jammed against obstruction
Check prop for obstruction due to weeds, fishing line, rope, etc.
Reset and try again. If no obstruction is found, call KL Industries
for replacement.
Defective control switch
Call KL Industries for replacement.
Problem: Motor runs but will not move boat
Missing prop, broken shear pin
Replace prop and/or shear pin. Tighten prop nut.
Problem: Motor runs slow
Low battery charge
Check battery water level. Charge battery.
Prop partially obstructed by fishing line, weeds, etc.
Raise motor, remove boat from water, carefully inspect and clean
prop. Remove prop and any line, rope, weeds, etc. that may be
wound around it.
Water in motor due to defective seals
Check for water in motor, replace motor if water inside.