46
Connecting the hob to the main power supply
16. Connecting the hob to the mains power supply
The power supply should be connected in compliance with the rele-
vant standard, or a single-pole circuit breaker.
The method of connection is shown below.
• If the cable is damaged or needs replacing, this should be done by
an after-sales technician using the proper tools, so as to avoid any
accidents.
• If the appliance is being connected directly to the mains supply,
an omnipolar circuit breaker must be installed with a minimum
gap of 3mm between the contacts.
• The installer must ensure that the correct electrical connection
has been made and that it complies with safety regulations.
• The cable must not be bent or compressed.
• The cable must be checked regularly and only replaced by a pro-
perly qualified person.
• The installer must to use the H05GG-F power cord.
2
Note:
Hob
blue
and
grey
connect in box on
blue
clamp.
If you are not sure, please
contact customer service
.
When connected to
two phases
:
Disconnect the
connection
.
Black on
L1,
Brown on
L2
Blue and gray do not disconnect!
Gerät ist
nicht
für den Betrieb
mit einem Schuko-Stecker geeignet
