11
If all the above checks fail to remedy the
fault, it is possible you have a more seri
-
ous problem.
In no circumstances try to repair the
electronic/electrical components in the
appliance.
Contact your Customer Service.
Motor problems
• Is there a power supply failure?
• Is the plug properly inserted in the
socket?
• Has a fuse blown?
The hood capacity is insufficient
/ operating noise has increased:
• Is the size of the exhaust air pipeline
sufficient?
• Is the exhaust air duct blocked?
• The cross section of the air pipeline
(from the hood to the wall box incl.)
should be 150 mm.
• A smaller air pipeline cross-section
can possibly impair the motor power.
• The air flow can be obstructed if the
wall box is fitted with a fly mesh.
• If this is the case remove the fly mesh.
• If the cover plate of the wall box
has fixed, very inclined louvres, you
should remove the plate to check
whether this solves the problem.
• Mount a cover plate with movable lou
-
vres in the wall box, as this will least
obstruct the air flow.
• Is / are the filter(s) clean?
• Was / were the carbon filter(s)
installed more than six months ago?
Then this/these should be changed.
• Is the air taken from the kitchen being
replaced by sufficient fresh air, so that
no partial vacuum is being produced
in the room?
When the lightning fails:
• Does the lamp need changing?
• Has the lamp been properly fitted and
seated in the holder up to the stop?
• Is the fuse blown or has the circuit
breaker tripped out?
6. Fault – what to do if ...
6.1 Customer service
Fault – what to do if...
For technical queries concerning your
appliance please contact the customer
service office of your dealer.
The type and rating plate is located in
-
side the appliance (remove the grease
filter)
EN
