Page 2
265 E. Messner Drive Wheeling, Illinois 60090-6495 PH: (847) 541-4511 FX: (847) 541-6332
Email:[email protected]
I/E – “Internal” or “External
”
##
–
Encoder speed. Speed will read “0” prior to initiating
the first print.
Print Head Status is displayed under the Encoder Info icon.
If a valid print cartridge is sensed, the icon will display ink
level. If no valid cartridge is detected, the icon displayed will
be an “X” in a red circle.
L. Default Configurations
Encoder: External. Better.
Maximum speed using “Better Mode” in this version is about
inches/sec. For printing at a higher speed, switch to “Draft
Mode” in “Print Config”
ToF: Internal. 2.5 inch trigger delay.
Density: 50%
M. Notes
-Do not change any settings while in the middle of a print job.
To change settings, ensure that a job is not running. Attempting
to change settings during a job will result in no setting
changes.
-USB keyboard must be connected prior to power-up.
-MicroSD card must be inserted to boot up the
Kiwi Matrix HD Ink
Jet System.
-Internal Encoder is not recommended for barcode printing.
-To track speed, ensure that the encoder wheel is set on the
conveyor.
-If settings are not showing any sign of change while outside of
a print job, ensure that security has been turned off to allow
for settings changes.