8
9
Instructions for use
Getting started
•
Insert the mains adaptor into the DC IN socket (10)
•
Plug the mains adaptor into the nearest mains socket and switch it on
Installing the backup battery for clock and alarm settings
In order to offer consistent clock settings and alarm functions, the unit uses a backup battery system. This means that in the
event of a power failure, all the settings (clock, alarms and FM presets) of the unit will remain saved.
nOTe The XDock3 will nOT power on with battery power alone, the batteries are for settings backup only.
– Make sure the connection between the DC adapter and the unit is secure. This is important, because during battery
replacement it is possible for all settings to be lost if clock and alarm have already been set
– Locate the battery compartment on the bottom of the unit and open
– Insert two AAA batteries, following the correct polarity (+/–) drawings inside the battery compartment. For longer battery
life, alkaline batteries are suggested. Please note that new and used batteries should not be mixed. Likewise, alkaline,
standard (carbon-zinc) or rechargeable (nickel-cadmium) batteries should not be used together
Basic use
Turn the XDock3 on
•
Firstly, make sure the mains adaptor is connected and the ON/OFF switch (9) on the rear of the unit is in the ‘ON’ position
•
Now press (don’t hold) the Power/Mode button (1)
note:
Pressing this button again will cycle through the Aux/iPod/iPhone and Radio modes
Put the XDock3 into standby mode
•
Whilst in radio/iPod/Aux mode, press and hold the Power/Mode button (1) for 2 seconds
set the clock
Simply dock your iPod or iPhone and the XDock3 will automatically adopt the exact same time. Alternatively:
1. With the XDock3 in standby mode, press (don’t hold) the Menu button (2)
2. Press the Up (6) or Down (5) button to select between 12 hour or 24 hour clock modes followed by Menu (2) to confirm
3. Press the Up (6) or Down (5) button to increase or decrease the hours, then press Menu (2) to confirm
4. Press the Up (6) or Down (5) button to increase or decrease the minutes, then press Menu (2) to confirm
5. The time will now be set
alarm1
1. Put the XDock3 into standby mode
2. Press (don’t hold) the Vol– (3) button
3. Press the Up (6) or Down (5) buttons to select between buzzer, iPod, or radio to wake you up, followed by the Vol– (3) to confirm
4. Press the Up (6) or Down (5) buttons to change the hours, followed by the Vol– (3) to confirm
5. Press the Up (6) or Down (5) buttons to change the minutes, followed by the Vol– (3) to confirm
6. Press the Up (6) or Down (5) buttons to change the alarm volume, followed by the Vol– (3) to confirm
7. The alarm is now set
[continued...]
