4
5
Instructions for use
Set up
1. Remove all packaging material from the Select and place on a stable, level surface, close to a mains socket, out of direct sunlight
and away from sources of excess heat, dust, moisture, humidity, or strong magnetic field
2. Connect the plug to your mains socket
Power source
Please only use the supplied adaptor. Attempting to operate this system from any other power source may cause damage to the
system and invalidate your warranty.
Getting started
When plugged in, the LED display (15) will light up and the Select will automatically enter standby mode.
General operation
•
Press Standby (1/A) to turn the Select on or to put into sleep mode
•
While in standby mode the LCD display (15) backlight will be dimmed, and pressing any button once will turn the LCD display
backlight on
FM mode
1. When the Select is turned on, make sure the Antenna (11) is extended and placed in good position
2. Short press Mode (2/I) until you see an FM frequency on the LCD display (15)
3. To change station, short press Next/Previous Track (6/7/E) to change the frequency
4. Long press Next/Previous Track (6/7/E) for two seconds to automatically scan
Note:
When in FM mode, clicking Play Mode (L) on the remote will switch between Stereo and Mono
Setting a preset
1. Short press Memory (M) and short press Preset controls (G) to go through the list of numbers
2. Once you have found your desired number for your desired station, short press Memory (M) again
to save that number to that station
3. To revisit your saved channels short press Preset controls (G) until you find your desired number