KitchenAid Pro Line KHWV01RSS, Техническое образование

Страница: 14 / 104

2-6
Connect the inlet hoses to the washer
H. Hot water inlet C. Cold water inlet
H
C
1. Attach the red water inlet hose to the
washer’s hot (H) water inlet valve. Screw
on coupling by hand until it is seated on
the washer.
Laundry tub drain or standpipe drain
Connect the drain hose form to the corrugated
drain hose.
A. Snap either end of the drain hose form to the drain hose at
the point where the corrugation begins.
B. Bend drain hose over drain hose form and snap into place.
A B
To keep drain water from going back into
the washer:
Do not straighten the drain hose, and do
not force excess drain hose into standpipe.
Hose should be secure, but loose enough to
provide a gap for air.
Do not lay excess hose on the bottom of the
laundry tub.
Floor drain
You may need additional parts. See Floor drain
under “Tools and Parts,” page 2-1.
CONNECT THE INLET HOSES
IMPORTANT: Verify that there are rubber
washers installed in both ends of both of the
inlet hoses.
•
•
Connect the inlet hoses to the water
faucets.
Make sure the washer drum is empty.
1. Attach the red inlet hose to the hot water
faucet. Screw on coupling by hand until it
is seated on the washer.
2. Attach the blue inlet hose to the cold water
faucet. Screw on coupling by hand until it
is seated on the washer.
A. Coupling B. Washer
NOTE: Do not overtighten or use tape or seal-
ants on the valve. Damage to the valves can
result.
Clear the water lines
Run water through both faucets and inlet
hoses, into a laundry tub, drainpipe or bucket,
to get rid of particles in the water lines that
might clog the inlet valve screens.
Check the temperature of the water to make
sure that the hot water hose is connected to
the hot water faucet and that the cold water
hose is connected to the cold water faucet. •
•
3. Using pliers, tighten the couplings with an
additional two-thirds turn.