5
5
5
5
5
5
Bottom Door Hinge
For your convenience, the refrigerator doors have bottom hinges
with door closers. These closers allow the doors to swing fully
closed with just a gentle push.
IMPORTANT:
So that the closers feature will operate properly, the
doors must be removed only when open to a 90° angle to the front
of the cabinet. If one or both doors were not at a 90° angle when
removed, the bottom door hinge must be reset.
Reset the Door Hinge
1.
Lift the door from the bottom hinge pin and place it on a
flat surface.
2.
Using a driver with a #2 square bit, remove the bottom
hinge with the bushing from the cabinet.
3.
Insert the bottom hinge and bushing into the corresponding
slot in the bottom of the door.
NOTE:
Make sure that the base of the hinge is parallel to the
bottom of the door.
4.
Turn the hinge until the hinge base is at a 90° angle to the
bottom edge of the door.
5.
Remove the hinge from the door. Using a driver with a
#2 square bit, reattach the bottom hinge to the refrigerator
cabinet.
6.
The hinge is now reset and prepared for the door to be
replaced. See “Replace Refrigerator Doors” later in this
section.
A. Bushing
B. Hinge base
90˚
A
B
A. Hinge base parallel to the bottom edge of the door
A. Hinge base turned to a 90° angle with the
bottom edge of the door
A
90°
A
