KitchenAid KOSP 6610, Инструкция по эксплуатации

Страница: 12 / 16

• Remove the internal glass by lifting it by the side and removing it
from its position (Fig. 7).
• Remove the second and third piece of glass, paying attention to
the position of the lettering “REFLECTING SIDE” if present (Fig.
8).
• Follow the reverse procedure to refit the glass:
- the lettering “REFLECTING SIDE” on the intermediate pieces of
glass should be positioned so that it is legible;
- if an intermediate piece of glass does not have the lettering
“REFLECTING SIDE”, place it as close as possible to the internal
glass.
• Place the internal glass into its position, making sure that the
lettering “EASY CLEAN” is facing the upper part of the door (on
the plastic profile side).
• Replace and tighten the two glass supports A (Fig. 5 and Fig. 6).
Take particular care with the hinges when cleaning and/or dismantling
the door (Fig. 9).
Note: a slight gap between the internal glass and the side
posts on the door is normal as this acts as compensation for
the glass expanding when hot.
How to remount the door:
• Insert the hinges in their grooves and lower the door fully (Fig. 4).
• Lower the two catches again (Fig. 3).
• Fully close the oven door.
Changing the rear oven lamp bulb
• Disconnect the oven from the electrical supply.
• Let the oven cool before turning the lamp cover left to unscrew it
(see Fig. 10).
• Change the bulb (see note).
• Screw the lamp cover back on.
• Reconnect the oven to the electrical supply.
Note: only use 40 W - 230V lamps, such as E-14, T 300°C,
available from the Customer Care Centre. Important: do not
use the oven without replacing the lamp cover.
Care and Maintenance
(continuation)
12
Fig. 7
Fig. 8
Fig. 9
Fig. 10