25
Install Side Panel
If the built-in area depth is 25" (63.5 cm) or more, the side panels
can be installed inside the side trim or attached to the outside of
the side trim.
IMPORTANT: KitchenAid is not responsible for the removal or
addition of molding or decorative panels that would prevent the
refrigerator from being serviced.
1. For the inside side trim piece, slide the front edge of the
routed side panel into the trim piece.
2. Nail the rear edge of the panel to the support board.
Install Base Grille
There are two pieces to the base grille to allow for a custom fit:
the base grille itself and the skirt. The skirt can be added to the
base grille in order to extend it all the way to the floor.
1. Open the refrigerator door and measure the distance from the
bottom of the refrigerator cabinet to the floor.
2. Measure this same distance from the top of the base grille to
the closest “V” groove on the skirt. Use a knife to score down
the “V” groove and break the skirt at the score line.
3. Slide the skirt onto the base grille.
4. Then attach the base grille to the cabinet with the two screws
provided.
A. Support board
B. Side trim piece
A
B
A. Floor
B. Refrigerator cabinet bottom
C. Distance to be measured
A. Grille and skirt assembly
B. Measured distance from above in Step 2
C. Score “V” groove
A
B
C
A
C
B
