14
DESCALING THE ESPRESSO MACHINE
The descaling programme enables simple and effective descaling of your Espresso Machine.
Descale the Espresso Machine regularly, but a minimum whenever the “Clean ( )” indicator
is blinking. The frequency of descaling depends on the hardness of the water in your region.
Therefore, it is important to programme the Espresso Machine according to the water hardness
level of your location.
NOTE:
The descaling process runs in 4 phases, takes approximately 10 minutes and
must be completed before next use. At any time during the descaling programme you
can pause the cycle by pressing
button. And, resume too by pressing
button.
SET UP OF GROUP HEAD DESCALING
IMPORTANT:
Only use descaling solution intended for Espresso Machines.
1
Phase 1:
Place a container (~0.5 L) on the
Drip Tray below the Group Head. Press the
Clean cycle ( ) button for 3 seconds or
until Clean light is solid. Then, press
button to start first phase of decalcification
cycle.
Start/Cancel (
) will blink fast after the
first phase is complete. Empty the container.
2
Fill 250 ml water and 125 ml descaling
solution inside the Water Tank.
NOTE:
The clean cycle is designed to
run as per the above mentioned water
and descaling solution volumes.
The cycle cannot be completed with
any less volume than mentioned above.
1
Water
Descaling
solution
CARE AND CLEANING
Wash the Drip Tray, Portafilter, Filter
baskets, Milk Pitcher, and Drip Tray Plate
in warm, soapy water and rinse with clean
water. Dry with a soft cloth.
3
Clean the Steam Wand after every use.
Toggle the Mode Button to select Water.
Position the Steam Wand over Drip Tray or
into a cup. Press
button, wait 3 to 5
seconds.
Press
button to stop. Wipe down wand
exterior with a soft damp cloth.
4
NOTE:
To remove the Steam Wand press the Steam Wand Release Button.
W11331487C_01_EN.indd 14
W11331487C_01_EN.indd 14
26-04-2021 13:42:11
26-04-2021 13:42:11
