7
8
step 2: Pull the car seat out to
make sure it’s connected to
vehicle seat and the backrest
can be adjusted slightly.
1. This ECRS seat is installed forward and suitable for children with height of 100-150cm.
2. Suitable for models with ISOFIX systems which pass ECE R14 and with three-point seat
belt/seat belt with a retractor which pass ECE R16.
3.Don’t use force-bearing points without marking
setp 1: Please unfold the car seat.
(100-150cm) Seat installation mode
Attention
Don’t use force-bearing points without marking
step 3: place the child to the car seat, ensuring they are seated upright
against the backrest. Adjust the headrest to fit the child’s shoulder.
Pull out 3-point safety belt around kid, make the shoulder belt through
the guide hook at the bottom of headrest, lead the lap belt above the
child’s hip, make sure the lap belt is through the lower safety belt slot
under armrest, then insert the safety belt to buckle until you hear “click”
sound, tighten 3-point safety belt, make sure it is tighten and not twisted.
click
Cleaning and maintenance
Washing instructions
1.When not using the baby car seat, keep it in a dry and ventilated place to avoid damp and mold.
2. If dust is found on the seat surface, clean the safety belt, fabric and plastic parts with a damp
sponge and then air dry.
3.If accidentally drip food or drink onto the safety belt, remove the safety belt and rinse it with
warm water, then air it to dry.
4.If clean the entire cover, refer to the washing instructions
5.During the first washing, slight fading may occur, which is a normal phenomenon
Do not use solvents, chemical cleaners or lubricants on any part of this product.
Hand washable,
water temperature
below 30℃
Do not bleach
Do not dry
Do not iron
Removing cover
Step one Detach the female snap from male snap of seat .
Remove the headrest cover: as shown in figure 2, pull the cover out of car seat.
Remove the side wing cover: as shown in figure 3, open the snaps on both sides
of backrest, then you can remove the fabric cover.
Remove cushion cover: as shown in figure 4, open the snaps on handrail and
bottom, then remove the fabric cover
