KisanKraft
™
SELF PROPELLED REAPER
KK-SPR-1201P / 1202DV / 1203DH
: www.kisankraft.com
: +91.80.22178200
Page 20 of 72
A. Working of Cutter
1. The working faces of the moving and fixed knives should be on the same plane,
with the difference not more than 5mm.the space in the front should be not more
than 0.4mm, and the space on the back should be not more than 1.5mm. The
space between the moving knife, the rod and the friction plate of the knife
presser should be not more than 0.5mm. It is necessary to adjust the space,
keep the knife rod vertical, adjust the knife presser by increasing or decreasing
the spacer, or to replace the knife, so as to keep the above status.
2. The beginning and ending lines of the central route of all the moving knives
should coincide with the central lines of the neighboring fixed knives, with the
difference not more than 5 mm. If it does not coincide, adjust the length of the
connecting rod accordingly.
3.
Check the riveting of the moving and fixed knives if there’s more than 1/3 knives
lost or damaged, it would be necessary to replace the knife. It’s also required to
check the bolt of the knife presser to avoid any loosening.
4. Start up the diesel engine with crank to move flexible. If there is any block or
tightening, it is advised to adjust the gap of the knife presser by increasing or
decreasing the spacer.
B. Working of Conveying Chain:
1. For the proper tension rate of the upper and lower conveying chains, it should
make the turning smoothly. It is available by loosening the adjustable nut of the
passive sprocket to move left and right, so as to change the tension of the
conveying chain.
2. Check the tines and riveting of the upper and lower conveying chains, and repair
them accordingly if there is any loosening or is lost.
3. Check the correspondence of the tines on the upper and lower conveying chain.
Please adjust if it is not correspondent.
Working of Grain-Lifter
1. The pressing springs of five grain-lifters should keep close to the baffle, but not
too tight. The biggest gap should not be more than 10mm. if not, please change
the position of the pressing sprint by loosening the nut.
2. If the meshing position of the star wheel and the tine is not in the middle, it is
advised to loosen the adjustable nut on the standing pole of the grain-lifter, and
then to adjust the length of the adjusting axle, so as to adjust the height of the
star wheel accordingly.
3. If the tine shaped belt on the grain-lifter loosens, loosen the fixed bolt of the tine-
shaped wheel, adjust accordingly and then fasten it.
Working of Placing Angle:
The angle between the placing and the moving direction could be 90
o
+ 20
o
. It could be
adjusted according to the actual status by adjusting the bending degree of the crop leading
plate.
Working of Clutch:
A. Working of Turning Clutch Pulling Line:
Note:
Whether the turning clutch is cut off while clenching the handle of the turning
clutch, and whether it is connected while unlocking the handle?
