KisanKraft
®
Shoulder Mounted Baffle Type Reaper
KK-SBC-4502, KK-SBC-3804
: www.kisankraft.com
: +91.80.22178200
Page 14 of 32
Transportation
1.
When hand-carrying the product, cover over the
cutting part if necessary, lift up the product and carry it
paying attention to the blade.
2.
Never transport the product over rough roads over
long distances by vehicle without removing all fuel
from the fuel tank. If doing so, fuel might leak from the
tank during transport.
Application
If the Brush cutter is fitted with
cutting string
as trimmer as attachment, it is used for
cutting grass
grown in
park, garden
and
around tree
or
fence.
If the Brush cutter uses
metal cutting blade
as attachment, used for
cutting grass, weed
or
light plant.
When Brush cutter uses
metal (TCT) cutting blade
with
paddy guard
as attachment, used
for harvesting
paddy
,
wheat
and other
cereal crops.
Note
: Any other purpose not specified and permitted in this manual may damage device
and cause serious injury to the user. Do not use this device to cut thorn, shrub or bush.
The manufacturer shall not be responsible for damage caused by wrong operation.
Parts Description
KisanKraft
®
Shoulder Mounted Baffle Type Reaper
KK-SBC-4502, KK-SBC-3804
: www.kisankraft.com
: +91.80.22178200
Page 19 of 32
Mixed fuels which have been left unused for a period of one month or more may
clog the carburetor or result in the engine failing to operate properly. Put
remained fuel into an air-tight container and keep it in the dark and cool room.
Please ask for “mixed
petrol for air-cooled 2-
cycle engines” at your nearest gas
station, or use fuel made by putting unleaded petrol for automobiles and air-
cooled 2-cycle engine oil into a mixing container in accordance with the
following ratios and then shaking to mix well.
HOW TO MIX FUEL:
1.
Measure out the quantities of petrol
and oil to be mixed.
2.
Put some of the petrol into the
clean, approved fuel container
supplied.
3.
Pour in the oil and agitate well.
4.
Be careful that, if the agitation is
insufficient, there is an increased
danger of early piston seizing due to
abnormally lean mixture.
Mixing ratios
:
When using commercially available 2-
cycle oil:
25:1
(
40 ml of oil for every 1 liter of petrol)
FUELING THE UNIT:
1.
Untwist and remove the fuel cap. Rest the cap on a dustless place.
2.
Pour fuel into the fuel tank to 80% of the full capacity.
3.
Fasten the fuel cap securely and wipe up any fuel spillage around the unit.
4.
Fill 60-80 ml oil into the oil tank. (in case of 4-stroke engine)
WARNING
1.
Select bare ground for fueling.
2.
Move at least 10ft (3m) away from the fueling point before starting the engine.
3.
Stop the engine before refueling the unit.
4.
In the case of storing the product for a long period of time, clean the fuel tank
after rendering it empty. Next, activate the engine and empty the carburetor of
the composite fuel.
Operation
Starting the Engine:
WARNING
The cutting head will start rotating upon the engine starts.
1.
Feed fuel into the fuel tank and tighten the cap securely.
2.
Rest the unit on a flat, firm place. Keep the cutting head off the ground and
clear of surrounding objects as it will start rotating upon starting of the engine.
