KisanKraft
®
AGRICULTURAL INTER-CULTIVATOR
KK-IC-410P
This warranty is null & void, if you fail to register the warranty with KisanKraft
by sending the KisanKraft Copy with dealer’s stamp
. KisanKraft Limited
: +91.80. 6835 7800
Page 16 of 52
CONNECTING THE ATTACHMENTS
1)
When rotating, you should take away the wheels, fix hexagonal sleeve of rotary device on
both sides of the hexagonal shaft with boltsM8×55. Attention: there are blade units on both
sides; make sure the blade cutting edge works firstly when the Inter-Cultivator runs. After
the rotary blades are installed, you must install the safety panel to prevent injures by
blades. Cultivator depth can be adjusted through adjusting resistance rod.
2)
When ditching, you should take down resistance rod, install the ditcher and adjust its
depth and height. After finishing these, you can do ditching work. (Look at picture3)
Range of ditching scope: 14cm-40cm
Range of ditching depth: 11cm-25cm
3)
Short-distance transportation
Install forearm of Inter-Cultivator case on the drug bar of running gear and install wheels
on the driving shift of the running gear. After finishing these, you can transport. The rated
load is 250kg. Under the rated rotary speed of diesel engine, the fast speed is around
10km/h and slow speed 1.8km/h.
4)
Multifunctional work
5)
Take off
the resistance rod, rotate the handle for 180°, and put the auxiliary shift on “L”
position. Connect the implements (reaper,intercultivator, mower, grass cutter, sprayer
pump and etc.) to gearbox back cover, PTO side, screw nuts on the 4 bolts there. Put the
shift lever on neutral position “0”, put the auxiliary shift lever on low-speed position “L”, use
the rear shift handle to start working with the multi- functional implements.
Shifting position
Connecting position
