KISANKRAFT KK-IC-406D, Руководство пользователя

Страница: 28 / 56

KisanKraft
®
AGRICULTURAL INTER-CULTIVATOR
KK-IC-406D
KK-IC-406D (Electric Start)
This warranty is null & void, if you fail to register the warranty with
KisanKraft by sending the KisanKraft Copy with dealer’s stamp.

: www.kisankraft.com

: info@kisankraft.com

: +91.80. 6835 7800
Page 28 of 56
1. Clearance adjustment of mesh of angel gear in
gearbox (See Figure 10)
a) When lateral clearance of mesh of the gear
△
＜
0.05mm, we should put some vulcanized
paper to enlarge the clearance between the
gearbox and the traveling box.
b) When lateral clearance of mesh of the gear
△
＞
0.3mm, we should reduce the clearance to
0.05-0.10 mm between the bearings and gear
Ⅱ
shaft
2. Clearance adjustment of mesh of the gear in the
running case. (See Figure 11)
a) When lateral clearance of mesh of the gear
△
＜
0.05mm, we should increase adjustment
pad
Ⅰ
by 0.2-0.3mm to enlarge the clearance,
and change vulcanized paper board
Ⅱ
and
adjustment pad. To ensure the axial clearance
of the gear is 0.05-0.15mm.
b) When lateral clearance of mesh of the gear
△
＞
0.3mm, we should reduce adjustment pad
Ⅰ
, meanwhile the axial clearance of gear
Ⅱ
is 0.05-0.15mm, or increase the adjustment
pad
Ⅱ
, meanwhile ensure the axial clearance
of gear
Ⅰ
is 0.05-0.15mm.
Engine Troubleshooting:
Difficulty in starting or failure to start :
Cause Remedy
A. Extremely cold weather
Pour in 3-5g engine oil in air intake pipe or
spray hot water at the top of the cylinder
head.
B. Failure of fuel system
1. Fuel is frozen Replace the fuel, apply proper fuel type.
2. Water in fuel Clean oil tank and replace fuel
3. Failure of injector
Adjust pressure or clean up carbon deposit,
grind or replace parts
4.
Injector doesn’t work or bad fuel
supply of oil pump
Fasten type T bolt of oil supply pipe,
evacuate air in the pipe.
C. Insufficient compression force
1. Nuts of cylinder head is
loosened, or cylinder gasket is
damaged
Fasten nuts or replace gasket
2. Piston ring, piston, or cylinder
liner is worn out. Repair or replace the part whichever is
necessary.
3. Piston ring is banded or broken Clean or replace the piston ring