Kisae DMT1230, Руководство пользователя

Страница: 8 / 24

REV D Page 8
4. INSTALLING THE CHARGER
WARNING: KISAE Technology recommends that all
wiring be done by a certified technician or
electrician to ensure adherence to the applicable
electrical safety wiring regulations and installation
codes. Failure to follow these instructions can
damage the unit and could also result in personal
injury or loss of life.
CAUTION: Before beginning your unit Installation,
please consider the following:
•
The unit should be used or stored in an indoor
area away from direct sunlight, heat, moisture or
conductive contaminants.
• When placing the unit, allow a minimum of three
inches of space around the unit for optimal
ventilation.
Mounting the Charger:
•
Choose an appropriate mounting location.
•
For installing in an indoor location, the unit should be
mounted vertically (with the battery terminals facing
downwards). This provides the best thermal performance and drip protection. The unit should NOT
be mounted upside down.
•
For installing in a boat or marine environment, the unit should only be mounted vertically (Battery
Terminals facing downwards) to provide adequate drip protection.
•
Use the base of the charger as a mounting template to mark the positions of the fixing screws.
•
Drill the 4 fixing holes and place the Charger in position and fasten the unit to the mounting surface.
Note: The charger is designed to be permanently mounted.
5. CONNECTING THE CHARGER
Chassis Ground Connection:
DANGER: The unit chassis has to be grounded properly. Never operate the Charger without
proper grounding. Failure to do so will result in death or serious injury. Ground
connection to the charger must comply with all local and application-specific codes and
ordinances.
•
Connect the unit
’s chassis ground to the common ground point through the ground stud
“
Chassis Ground
” located near one of the unit mounting slots.
DC Inputs and Output Wiring:
WARNING: The DC wiring used must be of appropriate size. An individual over-current protection
device usually within 7 inches (17.8cm) of each battery bank is required. A DC disconnect switch is
also recommended. Both devices must be rated for DC voltage and current to withstand the short
circuit current available from the connected battery bank. Both devices must match with the size of
the DC wiring.