KIRLOSKAR KMW Univator, Руководство оператора и по обслуживанию

Страница: 24 / 56

4.3.6. Lubrication of Grease points.
4.3.7. Leakages of Oil/Grease
4.3.8. Blades – Broken/Worn Out/Bend
4.3.9. Any Damages
4.3.10. Any Cracks
4.4. PARKING :
Comply with the following instructions in order to ensure that the machine remains stable
when released from the tractor:
4.4.1. Position the parking stand as shown in the figure 12
4.4.2. If the machine has a safety ram, position the pin as shown in the figure (1 Fig. 12).
4.4.3. Rest the drive line on the relative support.
Image: G
4.5. STORAGE
4.5.1. Proceed in the following way at the end of the season or if the machine is to remain
unused for a long period of time:
4.5.2. Wash the machine and dry it. Make sure that all fertilizer and chemical products have been
removed.
4.5.3. Carefully check the implement and replace any damaged or worn parts.
4.5.4. Fully clamp all screws and bolts, particularly the ones that fix the tines.
4.5.5. Thoroughly grease the implement and protect it with a plastic sheet. Store it in a dry
place. It is advisable to proceed with the following inspections before the machine is set
at work again:
4.5.6. Check the oil levels in the gearbox and transmission unit. Top up if necessary.
4.5.7. Check the greasing points and add grease if required.
4.5.8. Check all bolts and tighten them if necessary.
4.5.9. Careful compliance with these instructions will be all to the advantage of the user who will
be sure to use an implement in perfect conditions when work begins again.
The laws of the country where the machine is used, and particularly anti-pollution laws, must
be observed if the machine should be scrapped. Remember that the Manufacturer is always at
your disposal for any assistance or spare parts as may be required.
4.0
MAINTENANCE, SERVICING & REPAIR
22