KIRAMI Micu, Инструкция по установке

Страница: 15 / 40

© Kirami Oy, Finland
Page 3
Instrcution manual: Kirami Micu outside heater for hot tubs
Be careful, the edges of the chimney are very sharp. Use protective gloves!
Fire safety
If the heater is located near
buildings, for example on the side of
a terrace, the distance of the
chimney from any combustible
materials must be adequate.
Remember to check the distance
both laterally and vertically so that
there isn’t any risk of fire. Local
rules may vary.
Notice also the fire safety in front of
the furnace. There shouldn’t be any
combustible materials in front of the furnace. There should be an area, which is demonstrated in
the picture that should be made of incombustible material such as concrete, sand or metal.
Usage
Warning!
Never start the fire when the tub is empty or the
water level is insufficient! Heating a non full tub
will destroy the heater!
Always check the amount of water in the tub before
lighting the stove!
The tub must always be filled so that the water
level is at least 5 cm above the upper pipe of the
heater (picture on the right). Only then it is safe to
start the fire.
Do not start emptying the tub until the fire in the heater is
completely out! Heating a non full tub will destroy the heater!
The water in the tub must not be allowed to freeze during the
winter. Empty the tub or make sure that the water is heated
adequately.
The heater cannot be connected with a circulation pump! It will not
stand the pressure, since it has been designed to use only
gravitational free circulation.
15/40
12.02.2021