KIRAMI FinVision, Инструкция по эксплуатации

Страница: 20 / 25

20 / 25 INSTRUCTION MANUAL: Kirami FinVision sauna
Preset timing
- The yellow LED is lit when the preset timing is active. The time remaining before the heater is
switched on is shown on the display.
- Once this time has elapsed, the heater will be switched on, and the On/Off LED will be lit red.
- The preset time will not be saved in the memory, but will reset to zero after use.
- When the preset time is being set, the yellow LED flashes. At first, the timing is staggered by
intervals of 30 minutes and after that by an hour.
Power-on time
- The remaining power-on time is shown on the display.
- At first, the timing is staggered by intervals of 15 minutes and after that by half an hour.
Power-on
- When the heater is switched on, the temperature of the sauna is shown on the display.
- Optionally, the display can be set to show the remaining power-on time or to alternate between the
time and the temperature – see the section ‘Settings’.
- As soon as the heater reaches the predetermined temperature, the On/Off LED will be lit green, and
the elements will not be powered.
- Once the heater has cooled down enough that the elements are powered again, the On/Off LED will
again be lit red.
- The heater remains operational if the power outage lasts less than three minutes. When the power
supply resumes after a power outage of less than three minutes, the heater will resume its operation
from the point where it was before the outage.
If the outage lasts longer than three minutes, the heater is switched off.
The settings will always stay in the memory regardless of the duration of the outage.
You can find more information in the user instructions of Narvi’s KOTA Saana.
Installing the doorknob
The sauna door has already been attached, but the doorknob still needs to be
installed as shown in the image.
Lighting
The end customer is responsible for connecting the sauna to electricity. If there is no need in
the sauna for additional electricity for other reasons, such as an electric sauna heater, the
electricity needed for the sauna lighting can also be provided with an approved electric
cable reel. The sauna already has LED lights installed under the benches. The space under
the benches has a socket for the LED lights, which can be accessed through a hatch from
outside the sauna. You can power the lights by plugging them into the socket. The lights are
always on when they are plugged in, there is no separate switch. The LED lights only
consume a small amount of electricity, which means that mood lighting can be on even if the
sauna is not in use.