Kipp & Zonen LAS, Инструкция по эксплуатации

Страница: 32 / 75

31
4.1.2 Original COMBILOG module settings and programs
Depending on the
LAS-BET / LAS-RET configuration either 1 or 2 (or more) COMBILOG data loggers
are included in the system. The data logger(s) are pre-configured by Kipp & Zonen and will
automatically start measuring once connected to a power supply. If necessary the user can re-
configure the data loggers using the COMBILOG support software, e.g. when extra sensors are
connected. For further instructions the user is referred to the COMBILOG instruction manual and
COMBILOG support software. The original program(s) of each data logger can be found on the
supplied CD.
In general the main configuration of the COMBILOG data loggers of the LAS-systems is as follows:
A. LAS-system with RF telemetry link (=
LAS-RET , see Figure 1)
A.1 Original configuration COMBILOG 1 (Type 1020, MASTER ) (see Figure 20):
Location: Station-RET
Name:
Kipp
Filter freq.: 50Hz or 60Hz rejection
Auto off: Disabled
LED: Enabled
Address: 1
Protocol: Profibus/ASCII
Baud rate:
19200
Char format: 8n1
Answer delay: 1 Char Timeout
Timeout: 1 s
A.2 Original configuration COMBILOG 2 (Type 1020, SLAVE ) (see Figure 21):
Location: LAS-RET
Name:
Kipp
Filter freq.: 50Hz or 60Hz rejection
Auto off: Disabled
LED: Enabled
Address: 2
Protocol: Profibus/ASCII
Baud rate:
19200
Char format: 8n1
Answer delay: 1 Char Timeout
Timeout: 1 s