To prevent the possibility of creating a spark near the
battery, connect charging cable first to the generator,
then to the battery. Disconnect cable first at the battery.
Before connecting charging cables to a battery that is
installed in a vehicle, disconnect the vehicles grounded
battery cable. Reconnect the vehicle's grounded
battery cable after the charging cables are removed.
This procedure will prevent the possibility of a short
circuit and sparks if you make accidental contact
between a battery terminal and the vehicle's frame or
body.
Do not attempt to start an automobile engine with the
generator still connected to the battery. The generator
may be damaged.
Connect the positive battery terminal to the positive
charging cord. Do not re-verse the charging cables, or
serious damage to the generator and/or battery may
occur.
The battery gives off explosive gases; keep spark,
flames and cigarettes away. Provide adequate
ventilation when charging.
The battery contains sulfuric acid (electrolyte). Contact
with skin or eyes may cause severe burns. Wear
protective clothing and a face shield.
-If electrolyte gets on your skin, flush with water.
-If electrolyte gets in your eyes, flush with water for at
least 15 minutes and call a physician.
Electrolyte is poisonous.
-If swallowed, drink large quantities of water or milk
and follow with milk of magnesia or vegetable oil and
call a physician.
KEEP OUT OF REACH OF CHILDREN.
WARNING
CAUTION
WARNING
-
-
Substantial overloading that continuously lights the
overload indicator light (red) may damage the
generator. Marginal overloading that temporarily lights
the overload indicator light (red) may shorten the
service life of the generator.
Be sure that all appliances are in good working order
before connecting them to the generator. If an
appliance begins to operate abnormally, becomes
sluggish, or stops suddenly, turn off the generator
engine switch immediately. Then disconnect the
appliance, and examine it for signs of malfunction.
If an overloaded circuit trips the AC circuit breaker,
reduce the electrical load on the circuit, and wait a few
minutes before resuming operation.
Output Indicators
The output indicator light(green) will remain ON during normal operating conditions.
If there is a short circuit or overloaded circuit in a connected appliance the output
indicator light (green) blinks and current to the connected appliance (s) will shut off.
When this happens disconnect the appliance (s) and stop the engine to investigate the
problem.
Determine if the cause is a short circuit or overloaded circuit in a connected appliance.
Correct the problem and restart the engine.
If the output indicator light (green) may blink again, consult your generator dealer.
The output indicator light (green) may blink at intervals of 2.5 seconds depending on
connected appliance (s) to the AC receptacles. It indicates that the output voltage has
dropped slightly. it does not matter as long as the connected appliances work properly.
DC application
The DC receptacle may be used for charging 12 volt automotive or marine batteries
only.
1. Connect the charging cables to the DC receptacle of the generator and then to the
battery terminals.
CAUTION
NOTE
