Kioti MEC 2230SW, Руководство пользователя

Страница: 141 / 178

7
-2
MaiNteNaNce
you can get burnt by touching
hot parts, such as the muf-
fler. Wait until hot parts have
cooled down after stopping
the engine.
•
WARNING
7
20. if a different type of anti-freeze
is to be used, fill the cooling
system with clean water, run the
engine for approx. 5 minutes and
drain the water. repeat this 2 to
3 times before adding new anti-
freeze.
13. Make sure to install the drain
plugs for radiator and engine be-
fore filling new coolant.
14. fill the tank with water and anti-
freeze (ethylene glycol) in ratio
of 50:50.
15. fill slowly the new coolant
through radiator filler with bleed -
ing air out from the air bleeder
bolt loosened.
16. squeeze the coolant rubber hos-
es several time before tightening
the bleeder bolt to make sure no
air left in hoses.
17. Make sure every plugs and caps
for cooling by system is inplaced
firmly.
18. test run the engine to find any
leakage.
19. the coolant mixture ratio may
differ by local climate. therefore,
contact your
kIoTI
Dealer for the
correct mixture ratio.
ChECkING spARk ARREsTER of
EXhAUsT pIpE (If EQUIppED) (R)
1. park the vehicle on level ground
and apply the parking brake firmly.
2. stop the engine and let the engine
cooled down sufficiently.
3. Loosen the fixing bolt and then re -
move the spark arrester.
4. apply WD-40 or equivalent to the
inner side and blow any residual
with compressed air. Do not blow
with compressed air too closely, or
the filter can be damaged.
5. If the filter is damaged, replace the
spark arrester with a new one.
Coolant Capacity
6.3 l (1.7 u.s gal.)
Water+ethylene glycol 50:50
UD130(MEC2230SW)-유럽향-07.indd 25 2015-10-28 오후 12:01:55