![Kioti KL135 Скачать руководство пользователя страница 29](http://html1.mh-extra.com/html/kioti/kl135/kl135_user-manual_1971613029.webp)
LOADER OPERATION 6-3
CAUTION
Before disconnecting hydraulic lines, relieve all hydrau-
lic pressure. Escaping hydraulic oil under pressure can
have sufficient force to penetrate the skin causing seri-
ous personal injury. If injured by escaping hydraulic oil
seek medical attention immediately.
Do not operate the loader if the fittings are leaking or
if the hoses are damaged. A sudden line burst would
cause the mainframe to drop suddenly, causing damage
to the tractor or loader or injury to personnel.
Initial Loader Operation
Before operating the loader, fully raise and lower the boom two
or three times. Then raise the bucket approximately (4)feet above
the ground and cycle the bucket cylinders three times. Lower the
bucket to the ground. Check the tractor hydraulic oil and the cor-
rect oil level.
CAUTION
Before leaving the machine, stop the engine, remove the
key, place all controls in neutral, and either set the park-
ing brake or place tractor in park as equipped.
Always keep cylinders in a retracted position when the loader is
not in use to guard against rust and contamination which may
cause damage to the cylinder rods or hydraulic system.
Cold Weather Operation
For smooth operation in cold weather, let the tractor warm up.
Slowly cycle the lift and bucket cylinders several times to warm the
oil in the hydraulic system. The loader may operate erratically until
the hydraulic oil has warmed to operating temperatures.
CAUTION
Operate controls only when seated in the operator’s
seat.
Loading Bucket
For the most efficient loading, slowly drive the tractor straight into
the material to be loaded and increase speed only after contact
has been made. Roll the attachment back a small amount and
slowly lift to break away the material. As the load increase, contin-
ue rolling the attachment back so as to get the maximum load. Re-
move the top levels first when loading from large piles of material.
When bucket is full, raise loader so the bucket is clear of material
and slowly back out of the pile.
Dumping Bucket
When in the dump area slowly drive the tractor forward and raise
the loader at the same time. Raise the loader to the height needed
to dump the bucket. Make sure to keep a level bucket position to
prevent spilling from the bucket. Dump the bucket, and keep all
movements smooth.
KL135-06.indd 3
2013-02-01 오전 11:19:59
Содержание KL135
