Kinor 16 CX-2M, Инструкция по эксплуатации

Страница: 15 / 17

Installation of the lens
Before the installation of the lens, check if the filter holder is in its correct position. It
may not touch the rear of the lens. Turn the eccentric closure of the mount ( 59) (see Fig.
1) clockwise reverse. Take lens in your hand and put it on the mount, being aware of
putting the bayonet in its hole. Then push gently. The helicoids of the lens must seat
inside the eccentric closure. After this, turn this eccentric closure clockwise to the
fastening of the lens. Then, check if the lens is not moving.
To remove the lens, turn to the reverse side the eccentric closure.
Fastening the camera on the support
Fastening the camera on the support accomplish by a screw the sharp pain battle 3/8".
The camera allows installation and fastening on any the support, which has screw with
thread 3/8"
Park the mirror in its correct position.
When watching through the viewer, push with your thumb the mirror button (63). The
mirror turns to stop in front of the ground glass. Then you are able see the complete field.