A ParaBeam can be dimmed by DMX using the DMX ONÉ. This is useful
when checking or trouble shooting a fixture. The DMX ONÉ can operate
next to the fixture in place of a dimmer board.
Note:
DMX overrides all manual settings
PARABEAM CONTROL SETTINGS
•
Set address “
001
” .
•
Set toggle switch to END of
LINE .
•
Turn
on
power switch.
Note: If multiple ParaBeams are
being tested address all to
“001”
and only set the LAST
unit to “END OF LINE”.
4
DMX-ONÉ CONNECTIONS
(A)
Plug in 5 pin XLR DMX cable into DMX
output plug and connect to a fixture’s
DMX Input plug.
(B)
Plug in power cable to DMX-ONÉ AC
power input. (100-240 VAC, 50-60Hz)
DMX ONÉ SETTINGS
(A)
Turn on power switch.
(B)
Set NUMBER OF CHANNELS
to “
001
”
(C)
Set RATE/DIM switch to
DIM
(D)
Use MASTER knob to control
dimming level.
NOTE: If a fixture loses its DMX signal it will hold it’s last DMX
command.
For this reason it is important to turn a fixture off using the
DMX commands.
To turn off a fixture using the DMX ONÉ:
•
Set RATE/DIM to
DIM.
•
Turn
MASTER down to Minimum.
•
Turn off power switch.
Содержание DMX-ONE
Страница 1: ...Operation Manual DMX ONÉ ...
