10
TROUBLE SHOOTING GUIDE
PROBLEM SOLUTION
Phone does not ring Make sure phone line cord is connected
to base unit and wall jack
Ringer volume is too low Check if ringer volume set on low (see
page 11 for HS Ringer Vol adjustment)
Phone receives but cannot Is the dial mode in accordance with the
make calls local telephone company
FCC Interference Information
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference;
and (2) This device must accept any interference received, including
interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna (that is, the antenna for radio or
television that is “receiving” the interference).
• Reorient or relocate and increase the separation between the
elecommunications equipment and receiving antenna.
• Connect the telecommunications equipment into an outlet on a circuit different
from that to which the receiving antenna is connected
FCC RF Radiation Exposure Statement
The installation of the base unit should allow at least 20 centimeter between
the base and persons to be in compliance with FCC RF exposure guidelines.
For body worn operation, the portable part (handset) has been tested and
meets FCC RF exposure guidelines.
This device must not be co-located or operating in conjunction with any other
antenna or transmitter. The changes or modifications not expressly approved
by the party responsible for compliance could void the user’s authority to
operate the equipment.
