alkingPad.
Mode Switch
Short press: switch to manual mode.
Long press: switch to
S
tandby mode.
5. Remote Controller Notice
7. Error Warning Light
11
12
If the remote controller has no response
or you change a new one, the remote
controller and walking device need to
re-establish communication.
Remote control pairing method:
Restart the WalkingPad, press and hold
down the mode switch button on the
remote control immediately, hearing the
sound of "Beep" indicates the success of
pairing. Note: During the operation, the
remote control should be close to the LED
display panel of WalkingPad.
Error Warning Light on the display panel is off when WalkingPad works well.
When error occurs, Error warning light turns on and shows its error code.
6. Wi-Fi Warning Light
Long-term Lighting Mode: Indicates that
the machine is not connected to the cloud
server.
Long-term Lighting Out Mode: Successful
Connection between "Machine" and
"Cloud".
Flash Mode: Indicates that the machine is
networking or that the chip is being
upgraded.
8. Networking and firmware upgrade
By default, the factory is in the state of waiting for networking and can
directly use customer bundles.
When you need to enter the networking state again, you can press the
mode button on the walking machine for a long time in standby mode, make
a "Di" sound directly from WalkingPad, and the Wi-Fi warning light begins to
flicker.
OTA firmware upgrade, in the "MI Home" APP can receive update prompts,
see the update instructions, according to the prompts on the phone to
operate, automatically complete the firmware upgrade. In firmware upgrade,
Wi-Fi warning lights enter blinking status prompt.
Automatic mode
4. Description of automatic mode control (advance mode)
04 Learn to use WalkingPad
This is a challenging and higher-class mode, User can walk
on the walkingpad completely out of remote controller. We
only recommend those who have good sports skills or
walking-device experience to take the challenge.
Entering this area, the
walkingpad will start or
accelerate under the
automatic mode.
Entering this area, the
walkingpad will slow down
automatically under the
automatic mode.
E01: Communication fault;
E02: Voltage Protection;
E03: IPM Overheating;
E05: Overcurrent protection;
E06: Motor Protection;
E08: Sensor Fault;
E09: Wi-Fi Communication Fault.
