Proflame 2 Remote Control
Follow the procedure below.
• Install the 4 AA batteries into the battery holder (if present). Install the 3 AAA type batteries in the battery bay, located on
the base of the Remote Control. Note polarity of the batteries and insert them as indicated.
• Set the main burner flame “ON/OFF” command switch in “OFF” position.
• Set the main ON/OFF and the CPI/IPI switch in the closed position.
• Connect the AC power supply to the IFC.
• Press the SW1 button on the IFC module so the IFC will “beep” three (3) times and an amber LED is illuminated to indicate
that the IFC is ready to synchronize with a Remote Control within 10 seconds. With the batteries already installed in the
Remote Control
, push the ON button. The receiver will “beep” four times to indicate the Remote Control’s command is
accepted.
The system is now initialized.
Low battery power detection
The life span of the receiver batteries depends on various factors: quality of the batteries used, the number of ignitions of
the appliance, the number of changes to the room thermostat set point, etc. When the Battery Holder
’s batteries are low a
“double-beep” will be emitted from the IFC when it receives an On/Off command from the Remote Control.
When the Remote Control
’s batteries are low, a Battery Icon will appear on the LCD display before all power is lost. When
the batteries are replaced this icon will disappear.
LCD Display
ON / OFF Key
Thermostat Key
UP / DOWN Arrow Key
Mode Key
Battery Holder
37
