9
CAUTIONS AND WARNINGS
DO NOT CLEAN WHEN THE GLASS IS HOT.
THE USE OF SUBSTITUTE GLASS WILL VOID ALL PRODUCT WARRANTIES.
CARE MUST BE TAKEN TO AVOID BREAKAGE OF THE GLASS.
DO NOT OPERATE THIS STOVE WITHOUT THE GLASS DOORS OR WITH A BROKEN GLASS DOOR.
DO NOT STRIKE OR ABUSE GLASS.
GLASS REPLACEMENT
Only Robax ceramic or coated Neoceram glass may be used for replacement. It must be a minimum of 5mm thick.
REMOVAL OF THE GLASS DOORS
1. Remove top front grill by gently lifting the grill up and pulling towards you.
2. Remove the two screws on top of the door. Then lift the door out of door rest.
3. To replace glass, clean all material from door frame.Using a high temperature sealant (temperature-resistant to
500°F (260°C)) apply a bead of approximately 1/8" to all four sides of frame and insert glass with new gasket. Frame
should be placed on a flat surface with a small amount of weight pressing glass into sealant. Let dry approximately
15 to 20 minutes. The door can be reinstalled by reversing Steps 1,2.
LOG ASSEMBLY
1.
Remove front door as described above.
2.
Remove logs from carton (4) and inspect.
3.
Centre rear log on rear log holder attached to back of firebox above and to the rear of the pilot birner.
4.
Centre front log on front burner and push it back against stops. When correctly installed the log should not cover any of
the holes in the front burner.
5.
Place top logs across the front and rear logs in the slots provided.
6.
Purge gas lines and test pilot operation
WHILE DOOR IS STILL OFF.
7.
Tear ember wool into small, thin, irregular pieces and place evenly over the front burner.
8.
Replace glass door. The door must be installed before operating the fireplace.
f i r e - p a r t s . c o m
