Installation of HB Porcelain Liners - HB42PL
1. Remove Door from the fireplace by unlatching the 2 latches on top of unit.
2. Remove back Log Holder by removing 3 screws from face of Log Holder. The Log Holder will have to be re-
installed after the placement of the Back Panel.
For HB4736, remove Brick Filler Panel (See Ref. 1).
3.
Place Back Panel up against rear of firebox by tilting top of Back Panel towards you and sliding bottom of Back
Panel over burner system.
For HB47PL, use supplied screw to attach Back Panel to firebox (See Ref. 2).
4.
Loosen screws holding Brick Clip in place. Rotate Brick Clip out of the way and slide Side Panel up
against Back Panel. Side Panel tabs should engage top and bottom of Back Panel
(See Ref. 3)
. Rotate
Brick Clip down over Side Panel and tighten screw.
5.
Re-install Log Holder (and Brick Filler Panel if applicable) removed in step 2.Install Log Set as per
instruction and re-install Door.
18
Содержание HBZDV4224
