KINGSLEY – BATE
Fine Garden Furniture
0
ASSEMBLY INSTRUCTIONS FOR THE CL - 70
*NOTE
A TENON
2
B MORTISE HOLE
BACK LEG
FRONT LEG
I
inspect and lay the parts on a clean, flat, soft surface to
s
HAISE FRAME
the FRONT LEGS m aking sure to
e
STEP-
Unpack,
avoid marring the wood. Lay the C HAISE FRAME on its back side
with mortise holes facing up as shown in the assembly photograph.
NOTE:
During assem bly of the furniture please m atch all joint
with the corresponding letters or numbers stamped on the furniture.
3
C
STEP-II
Assemble
match the num bered tenons to the corresponding
mortise holes. With a rubber m allet gently knock
the front legs into place as shown in the pictures.
If you use a hammer be sure to place th
sanding block between the hammer and the leg.
This will prevent marring the wood.
STEP-III
After hammering the legs tight agains t the stretcher bar, insert the
locking dowels and drive them in gently.
Again, if you use a
hammer, please place the sanding block between the dowel and the
hammer to prevent any marring of the w ood. Do not force the
dowels. If dow els are not completely flush just sand aw
ay any
excess with the sanding block.
STEP-IV
rting the brass bo lts through the wheels, slide
Before inse
one washer onto each bolt. Insert the bolts through the
wheels and slide on the second washers and then connect
the wheel assemblies to the back legs (see pictures).
