Kingrex SLAP, Руководство пользователя

Страница: 12 / 16

-11-
With SLAP plugged in, press and PSU On then DC output , when Battery low to 10.5V, DC output will
auto cut off and front panel LED light will flashing green & read lights. For protect Battery not into deep
discharging (Deep discharging will damage the SLA battery. By pressing the CHARGE ON switch,
SLAP into charge mode (red light), Charge complete, front panel led will be green light)
Battery Replacement
Your battery should run any where from 2-3 years before eve needing to be replaced. Please follow the
instructions below for easy battery replacement.
1. Unplug unit from AC power source and disconnect all connected equipment.
2. Open the upper case- using a phillips screw driver, and hex screw driver to open the front panel
upside screw.
3. Using a phillips screw driver to unlock the main circuit board.
4. Carefully lift off main circuit board, using a phillips screw driver to unlock the battery.
5. Remove the 2 connecting wires from the battery.
6. You can now easily remove the battery from the unit.
i. Caution : Do not dispose of battery in fire.
ii. Caution :Do not attempt to open the battery.
iii. Caution : The following precautions should be taken, please remove watches, rings, etc… when
replacing the battery and use tools with insulated handles.
7. Place your new battery in the same position/direction and reconnect the wires red wire-po) and
black wire negative(-)
8. Please follow steps6. 5,4 and 3 (in that order) to reconnect the entire unit.
9. Please follow manual instructions in order to properly reconnect with your equipment.
Operating method
Switch on