KingKutter TG-48-XB, Руководство оператора

Страница: 18 / 36

18
SIZING PTO SHAFT
STEP 1
Cutting the PTO shaft to length. NOTE: Be
sure to cut equal lengths of each PTO shaft
section. Clamp end of PTO shaft in a vice
and cut off shield where marked.
(Figure 1
-A & 1-B)
STEP 2
Using cut section of the shield as a guide
cut shaft off the same amount. (Figure 2)
STEP 3
Repeat steps 1 and 2 for other PTO shaft
section.
STEP 4
Use a file to deburr PTO shafts. Clean up
all chips, burrs and filings from both ends of
the PTO shaft.
Figure 1-A
Figure 1-B
Figure 2