KI 9000 UM-10
46
QUICK REFERENCE GUIDE
–
KI 9800 Series Optical Light Source
Press and hold [LEVEL], then press [
] for 3
seconds to set output power to factory default.
Alternatively, press [POWER].
AutoTest:
To start AutoTest,
press [POWER] then press [AUTO].
To end, press [AUTO] again or turn the instrument off.
TamperLock Mode:
While in TamperLock Mode, user is prevented from
changing wavelength or laser output power.
Press
[POWER], turn the emitter on, then press and
hold [
] while pressing [LEVEL] for 5 seconds.
Display will show “codE’.
Enter 6 key sequence using any keys except
[POWER]. Triple
beep and “LOut” on display will
indicate completion. To cancel your entry before
completion, press [POWER].
While TamperLock is active, “
<<<
”
an
d “
>>>
”
symbols
will be displayed.
To clear TamperLock Mode, turn off instrument then
press [POWER] while holding down [
] and
[LEVEL].
When display show “codE”, enter six key
sequence.
If the correct sequence had been entered, “PASS” will
be displayed indicating that TamperLock had been
cleared.
In case where entered sequence was not correct,
“FAIL x” will be displayed (where x is attempt count).
TamperLock will be cleared after three unsuccessful
attempts.
