3
IMPORTANT SAFEGUARDS
1.
Staple Gun must not be loaded with staples and nails at the same time.
2.
Do not lubricate. The Staple Gun has been lubricated at the factory. Under normal
use it will not need further lubrication
3.
Do not hold the Staple Gun toward people, it could invite serious injuries.
4.
Store Staple Gun a dry locked cabinet and keep it out of reach of children.
SAVE ALL INSTRUCTIONS
GENERAL SAFETY RULES
WARNING!
Read and understand all instructions. Failure to follow all instructions
listed below may result in electric shock, fire or serious personal injury. The warnings,
cautions, and instruction discussed in this instruction manual cannot cover all possible
conditions and situations that may occur. It must be understood by the operator that
common sense and caution are a factor which cannot be built into this product, but must
be supplied by the operator.
WORK AREA
1.
Keep your work area clean and well organized. Cluttered benches and dark areas
invite accidents.
2.
Do not operate power tools in explosive atmosphere, such as in the presence of
flammable liquids, gases, or dust. Power tools create sparks which may ignite the
dust or fumes.
3.
Keep bystanders, children and visitors away while operating a power tool.
Distractions can cause you to lose control.
ELECTRICAL SAFETY
1.
Double insulated tools are equipped with a polarized plug (one blade is wider than
the other.) This Plug will fit in a polarized outlet only one way. If the plug dose not
fit fully in the outlet, reverse the plug. If it still dose not fit, contact a qualified
electrician to install a polarized outlet. Do no change the plug in any way.
2.
Do not abuse the cord. Never use the cord to carry the tool. Keep cord away from
heat, oil, sharp edges or moving parts. Replace damaged cords immediately.
Damaged cords may create a risk of fire.
3.
Avoid body contact with grounded surfaces such as pipes, radiators, ranges and
refrigerators.
4.
Don’t expose Staple Gun to rain or wet conditions. Water entering a power tool will
increase the risk of electric shock.
5.
During normal operation, if anything happens, the power should be cut off at once
and the tool should be checked and repaired
